FIBERGLASSING

    In September and  October I started the most tedious part of the boat build applying the fiberglass  to the hull. It’s also the most important part of the build. You want to make sure to get. this part right. It’s important to follow the boat plans closely. And make sure  to get the right amount of fiberglass on the seams of the plywood and then wrap the whole hull with the right amount of  1708 biaxle. Ask lots of questions to some of the builders who  have completed this process, if  you have any problem understanding what it is you need to do. I would also suggest using  peel ply , it will save you a ton of time and work. It’s expensive but well worth the cost.

































Comments

Post a Comment

Popular posts from this blog

SKEG And RUDDER

Image
    Building both the Skeg and the rudder took some research and some thinking through, In Nov. of 2024 thru Dec. Both were built. Especially  the skeg  because you have to basically manufacture a boat part. But what I did was build an exact replica of the part out of wood,, then wrap the part in fiberglass  and when it cured I was able to break up all the wood and remove the whole skeg that was made out of wood. I then filled the fiberglass mold with epoxy and chop strand and let it harden up.  I also had taken some threaded  stainless  steel rods and welded them together and put them into the mold when the epoxy was yes the right height  and they worked out perfect. And when I made the rudder I took a couple pieces of Douglass fir Marine lumber and  mahogany marine lumber and glued them  together. And followed the directions and shaped out a 580 Rudder.
Read more